Barracuda Networks SP4 Uživatelský manuál stáhnout pdf (Strana 15)

FIRST INSTALLATION RECOMMENDATIONS

ENG

Axel Technology srl

www.axeltechnology.com

10.3 FUSE REPLACEMENT

The power supply socket has an integral fuse drawer containing the AC power fuse and a spare, both of the same value.

BEFORE REPLACING THE POWER FUSE, MAKE SURE YOU HAVE THE RIGHT TYPE OF FUSE FOR

THE VOLTAGE TO BE PROTECTED.

USING WRONG FUSE TYPE WILL RESULT IN INSUFFICIENT PROTECTION.

Make sure that the power is switched off and the power cable is disconnected from the equipment.

Open the fuse drawer using a small blade screwdriver.

b. Replace the fuse located at the internal position

c. Push the fuse socket back into the original position (a.)

Perform the set-up under static control conditions. Static charges are likely to completely destroy one or

more of the CMOS semiconductors employed in the unit. Static damage will not be covered under

warranty

Basic damage prevention consists of minimizing generation, discharging any accumulated static charge

on your body and preventing that discharge from being sent to or through any electronic component.

Uninsulated dangerous voltage are inside the enclosure, voltage that may be sufficient to constitute a

risk of shock.

Always disconnect to AC Mains before removing the top cover

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 117 118

Žádné komentáře

Barracuda Networks SP4 Uživatelský manuál Strana 15